In offerta!
Varie e Altro 10 copie rimaste

Pug Keychain – new mew

@cyanidesugar_917682

ID Prodotto: pug_keychain_001

Anjali Neupane

Visita il negozio
0 reviews
This is a keychain is 60mm x 50mm, and prints in about 35 minutes. Quick and easy print, and is durable at 2mm thick. I used the Hueforge program to generate the STL for this print, and it only uses 3 filament changes/swaps. In the 3MF file you will see that I used a layer height modifier so that the base black layers are printed faster (at 0.2mm rather than 0.16). This is purely for efficiency. You can disregard it, and just print it at 0.08mm layer height the whole way through (except for the base at 0.16). If you do not have an AMS/MMU, just pause the print at the appropriate layer, swap your filament spool, and resume the print!
Dettagli
Altezza: 10 cm
Larghezza: 10 cm
Profondità: 10 cm
Unisex
18+ – Pieni diritti di consenso (Adulto)

Dettagli:

This is a keychain is 60mm x 50mm, and prints in about 35 minutes. Quick and easy print, and is durable at 2mm thick. I used the Hueforge program to generate the STL for this print, and it only uses 3 filament changes/swaps. In the 3MF file you will see that I used a layer height modifier so that the base black layers are printed faster (at 0.2mm rather than 0.16). This is purely for efficiency. You can disregard it, and just print it at 0.08mm layer height the whole way through (except for the base at 0.16). If you do not have an AMS/MMU, just pause the print at the appropriate layer, swap your filament spool, and resume the print!

-10% GCOIN 10.00 GCOIN 9.00

Leggi di più
Parti
  • Pug Keychain new mew
ASA
250 °C
100 °C
Yes
Yes
30%
0.2 mm quantità standard
Griglia

Descrizione:

This is a keychain is 60mm x 50mm, and prints in about 35 minutes. Quick and easy print, and is durable at 2mm thick. I used the Hueforge program to generate the STL for this print, and it only uses 3 filament changes/swaps. In the 3MF file you will see that I used a layer height modifier so that the base black layers are printed faster (at 0.2mm rather than 0.16). This is purely for efficiency. You can disregard it, and just print it at 0.08mm layer height the whole way through (except for the base at 0.16). If you do not have an AMS/MMU, just pause the print at the appropriate layer, swap your filament spool, and resume the print!

Totale:
Qtà:

Prodotti correlati

Recensioni degli utenti

Nessuna valutazione ancora. Sii il primo a valutare questo prodotto!

×

Feedback

Devi essere loggato per inviare una valutazione. Accedi.